Olitec RW400G Manual do Utilizador descarregar pdf (Página 58)

Appendix B: Configuring the PCs

In this section, we’ll introduce how to install and configure the TCP/IP correctly in

Windows 95/98. First make sure your Ethernet Adapter is working, refer to the adapter’s

manual if needed.

1. Install TCP/IP component

1) On the Windows taskbar, click the Start button, point to Settings, and then click

Control Panel.

2) Double-click the Network icon, click on the Configuration tab in the appearing

Network window.

3) Click on the Add button. Select Protocol, and then click Add.

Figure B-1: Add Network Protocol

4) Under Manufacturers on Select Network Protocol page, highlight Microsoft.

Under Network Protocols, highlight TCP/IP. Click OK. TCP/IP protocol will

take effect after reboot.

Figure B-2: Select Network Protocol

2. Configure TCP/IP for your computer

1) On the Windows taskbar, click the Start button, point to Settings, and then click

Control Panel.

2) Double-click the Network icon, highlight the bound TCP/IP tab in the appearing

Network window that appears. An example shown in the following figure:

- 54 -

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64 65

Sem comentários

Olitec RW400G Manual do Utilizador Página 58